Next Advance PC77-MAG - Manual (Page 7)

5
BE SAFE. ALWAYS MAKE SURE THAT THERE IS NO PRESSURE IN THE CELL BEFORE LOOSENING THE
BOLTS, AND THAT THE BOLTS ARE SECURELY FASTENED BEFORE APPLYING PRESSURE TO THE CELL.
USERS MUST ALWAYS WEAR PROTECTIVE APPAREL, INCLUDING EYEWEAR AND MUST BE TRAINED IN
WORKING WITH HIGH PRESSURE.
Operator’s Manual for the Pressure Injection Cell
TROUBLESHOOTING
In addition to the tips given below, a
thorough list of troubleshooting tips is at
http://www.nextadvance.com/api/index.cfm/c
ms.page/i/5063/pressure-injection-cell-troubl
eshooting.
If gas leaks through the top-base
interface of the pressure injection cell, the
three bolts might not be fully tightened or the
O-ring might be nicked or dirty or missing. If
the O-ring is dirty, wash it off with a soap and
water and return it to its groove. Contact us
for a replacement O-ring.
If gas leaks around the capillary, the
ferrule should be replaced.
If you do not see sample traveling
through the capillary after a few minutes,
check that the gas tank is supplying the
desired pressure (typically on the order of
several hundred psi) and that the 3-way valve
knob is pointing toward the pressurized gas
line.
SUPPORT
A thorough list of FAQs is at
http://www.nextadvance.com/api/index.cfm/p
roducts.info/c/427/Pressure-Injection-Cell-Ca
pillary-Loader#/FAQ.
If you cannot find a good answer there,
please contact customer service by email at
[email protected] or by telephone.
SPECIFICATIONS
Max. Pressure: 17 MPa (2500 psi)
Size: 18 cm (6.5 in.) long x 10 cm (4 in.)
wide x 19 cm (8 in.) high
Weight: 1.6 kg (3.5 lbs.)
Relative Humidity: 5 - 90% non-condensing
Operating Temperature: 4 - 40°C
Altitude: <2000m
Storage Temperature: -40 to 50°C
Meets requirements
Power Requirement (PC77-MAG model):
24V DC, 0.8 A
WARRANTY
Next Advance warrants its Products against
defects in materials and workmanship for time
periods which vary according to the Product.
Within these time periods, Next Advance will
replace or repair, without charge to the original
purchaser, any part which is defective.
Pressure Injection Cells Two years
The warranty is void if the Product is
defective due to product accident, product
modification, exposure to radiation other than
for sterilization, connection to an improper
electrical supply, lack of proper maintenance,
contamination, improper installation or misuse.
If the product is used in a manner not specified
by the manufacturer, the protection provided by
the equipment may be impaired. The warranty
shall also not apply to defects arising from fire,
flood, lightning or other conditions unrelated to
correct operation of the Product.
Next Advance’s liability is limited, at the
company’s election, to (1) refund of the
original purchaser’s purchase price for the
Product (2) repair of the Product, or (3)
replacement of the Product or defective parts.
Evidence of purchase by the original purchaser
is required. Next Advance may also request