Arcam CD33 - Manual (Page 5)

4 5
Using your CD player
POWER
CD33 COMPACT DISC PLAYER
PAUSE STOP PLAY LOAD
POWER
Press this button to switch the CD player on and off. When first
powered up with no CD installed the display shows:
LOAD
To install a CD, press ‘LOAD’ (or ‘OPEN’ on the remote control). The
CD tray opens – it accepts 12cm and 8cm discs. Place the CD in the
tray with the label facing uppermost. Press ‘LOAD’ again (or press
‘PLAY’, or gently push the tray in 5mm) to close the tray. You will see
the total number of tracks and total disc time, for example…
TRACK INDEX MIN SEC 1 2 3 4 5
6 7 8
The display returns to ‘0’ after a few seconds. The disc is now ready
to play.
PLAY
Press to play the CD. To restart from track 1, press ‘STOP’ and then
‘PLAY’. Make sure your amplifier’s input source selector is set to the
correct input.
STOP
Press to stop the CD playing. The display shows ‘0’ and the number
of tracks.
PAUSE
Press to pause the disc (interrupt play). Press ‘PAUSE’ again, or ‘PLAY’
to resume play from the same point.
SEARCH
Press to search backwards, or to search forwards for a
particular passage within the currently playing track. If the player is in
‘PAUSE’ mode the search is made at high speed with the sound muted.
SKIP TRACK
To start a CD with a track other than the first, press or to locate
the desired track.
To select another track during play, press or . The track is played
automatically after selection. Pressing once returns to the start of
the current track. To select the previous track, press twice quickly. To
go back two tracks, press three times, and so on.
COMPACT DISCS WITH TEXT
LOAD
You will see the total number of tracks and the total disc time with ‘CD
TEXT’ illuminated in the display. The artist and album title scrolls across
the display before returning to show the artist and total number of
tracks.
TRACK INDEX MIN SEC
CD TEXT
1 2 3 4 5
6 7 8 9 10
11 12
PLAY
The track number is briefly displayed, followed by the track title
scrolling across the display. The display returns to showing the track
number and time.
TRACK SELECTION
When a new track is selected, the track number is briefly displayed,
followed by the track title scrolling across the display. The display
returns to showing the track number and time.
NOTES
The track title is always displayed when a track is selected, either for
playing or programming.
The artist’s name is always displayed when the disc is stopped.
The ‘TITLE’ button turns the text display off.
The text display supports English only.