Kramer Electronics EDID Designer - Manual (Page 14)

12 EDID Designer - Using the EDID Designer
After successfully connecting to the device the Connect button becomes
Disconnect and next to it, the device type is displayed.
All inputs, outputs and default EDIDs are displayed in the appropriate panel.
4.3 Writing an EDID to an Input
Changing the EDID block on your Kramer device input channels is a powerful way
to take control of the signal your sources output. You can do that by writing an
EDID block EDID from a file, a default EDID, a local monitor or from an output to
an input.
Important: Before writing an EDID cube to an input, make sure to first sync
(save) the EDID to its source.
To copy an EDID to an input:
1. Click and drag the selected EDID from a saved EDID file, a local EDID File,
a default EDID or an Output to the desired input or several inputs.
When dropped, a warning message appears: