Kramer Electronics VP-790 - Manual (Page 2)

VP-790 Blending Images – Introduction i
Contents
1 Introduction 1
2 Setting the Basic System 2
2.1 Optical Alignment 3
3 Setting Blend Width 7
4 Warp Adjustment 10
4.1 Warp the Projection Image on to a Curved Screen 10
Figures
U
Figure 1: Basic Setup
U
2
U
Figure 2: Image Projection
U
3
U
Figure 3: Input Screen
U
4
U
Figure 4: Multiunit Screen
U
5
U
Figure 5: Two Overlapping Images on a Screen
U
6
U
Figure 6: Two Projected Images Displaying the Horizontal Bar Test Pattern
U
7
U
Figure 7: Left Hand Blend Width Correctly Adjusted
U
8
U
Figure 8: Blend Width Correctly Adjusted on both Scalers
U
9
U
Figure 9: The Cross Hatch (F) Warp Pattern
U
10
U
Figure 10: VP-790 Warp Generator Main Window
U
11
U
Figure 11: Auto Connect Window
U
12
U
Figure 12: Connect to Unit Window
U
12
U
Figure 13: A New 2x2 Grid
U
12
U
Figure 14: Setting a Grid Mesh of Nine Points
U
13
U
Figure 15: Setting the Warp
U
13
U
Figure 16: Adjusting the Linearity
U
14
U
Figure 17: Complete Linear Adjustment
U
15
U
Figure 18: Blend Curve Type – S-Curve
U
15