Kramer Electronics VP-774AMP - Manual (Page 63)

58 VP-774AMP - Port Tunneling
To setup and activate port tunneling on the VP-774AMP:
1. Set the dedicated port tunneling Ethernet connection port type and port
number through which the VP-774AMP will be passing RS-232 signals.
By default, the dedicated port settings are TCP, 5050.
To change these settings see the “Port Tunneling Configuration” in the table
in Section
12.4
.
2. Set the HDBT UART command (the table in Section 12.4 ).
By default, the settings are 9600,8,N,1
3. Make sure that the VP-774AMP is connected to Ethernet.
The VP-774AMP is now ready to tunnel RS-232 signals via Ethernet port tunneling.