Kramer Electronics VP-200xl - Manual (Page 12)

KRAMER ELECTRONICS LTD. 11
8 TROUBLESHOOTING
NOTES
1. Please note that if the output signal is disturbed or interrupted by very
strong external electromagnetic interference, it should return and stabilize
when such interference ends. If not, disconnect power from the machine and
reconnect again to reset the machine.
2. If the recommended actions still do not result in satisfactory operation,
please consult your KRAMER Dealer.
8.1 Power and Indicators
Problem Remedy
No Power
1. Confirm that power connections are secured at the
machine and at the receptacle. Make sure the
receptacle is active, outputting the proper voltage.
2. If there is still no power use a Philips screwdriver, to
remove two screws on both sides of the machine and
release the panel (e.g. VP-200xl).
3. Locate the fuse holder located inside your machine.
Confirm that the fuse is good by looking for the wire
connected between the ends of the fuse. If this wire is
broken, replace the fuse with another, with the same
rating.
4. Install the machine's cover by tightening its Philips
screws.
8.2 VGA/XGA Signal
Problem Remedy
No VGA/XGA
the output
device 1. Confirm that your source and output devices are
powered on and connected properly. The input of your
machine should be of an identical signal format at the
output of your source.
2. Confirm that any other device in the signal path have
the proper input and/or output selected.
3. Use a VP-800 together with a known working
monitor to help trace faulty cables and equipment.