Kramer Electronics VP-200AK - Manual (Page 5)

Overview
3
3 Overview
The Kramer TOOLS VP-200AK is a 1:2 distribution amplifier for UXGA (and
higher) resolution signals, as well as unbalanced stereo audio signals and/or
balanced stereo audio signals.
In particular, the
VP-200AK 1:2 UXGA / Audio DA:
Accepts one computer graphics input 1 , provides correct buffering and
isolation, and then distributes the signal to two identical outputs on
high-density 15-pin HD connectors
Accepts an unbalanced stereo audio input, and simultaneously
outputs two unbalanced stereo audio outputs on mini-plug
connectors, and two balanced stereo audio outputs on terminal block
connectors
With its video bandwidth exceeding 500MHz, ensures transparent
operation at high-resolution graphics modes such as UUXGA
(1600x1200)
Accepts TTL syncs 2
and provides ID bit control internally, as well as
separate controls for audio output level and UXGA equalization
Features KR-ISP™ advanced sync processing that ensures
compatibility with a wide range of computers (even if the sync level
is too low) by restoring the sync signal waveform to achieve a sharp,
stable image
Is 5V DC fed
To achieve the best performance:
Use only good quality connection cables 3 to avoid interference,
deterioration in signal quality due to poor matching, and elevated
noise levels (often associated with low quality cables)
Avoid interference from neighboring electrical appliances that
may adversely influence signal quality and position your Kramer
VP-200AK away from moisture, excessive sunlight and dust
1 At any resolution (for example, UXGA)
2 Allowing selection of KR-ISP/Normal technology by internal jumpers. Note that both the Hs (horizontal sync) jumper and
the Vs (vertical sync) jumper MUST be set identically
3 Available from Kramer Electronics on our Web site at http://www.kramerelectronics.com