Kramer Electronics VP-111K - Manual (Page 7)

Connecting the VP-111K UXGA Line Driver
5
5 Connecting the VP-111K UXGA Line Driver
To connect the VP-111K, as the example in Figure 2 illustrates, do the
following 1 :
1. Connect a computer graphics source (for example, a laptop) to the INPUT
15-pin HD (F) connector.
2. Connect the OUTPUT 15-pin HD (F) connector to an acceptor (for
example, a projector).
3. Connect the LOOP 15-pin HD (F) connector to an acceptor (for
example, a local display).
4. Connect the 5V DC power adapter to the 5V DC socket and connect the
transformer to the mains electricity (not illustrated in Figure 2).
5. Set the termination switch as follows:
If no acceptor is attached to the LOOP connector, press the
pushbutton in to the 75 setting
If a acceptor is attached to the LOOP connector, set the
pushbutton out to HI-Z setting
1 Switch OFF the power on each device before connecting it to your VP-111K. After connecting your VP-111K, switch on
its power and then switch on the power on each device