Kramer Electronics VM-4HC - Manual (Page 10)

VM-4HC - Connecting the VM-4HC 7
Repeatedly pressing the EDID SELECT button cycles through the EDID sources in
the following order:
If you attempt to acquire the EDID from an output that is not connected the default EDID is
acquired.

Output 1 (Output 1 LED lights)

Output 2 (Output 2 LED lights)

Output 3 (Output 3 LED lights)

Output 4 (Output 4 LED lights)

Default EDID (all LEDs light)

Auto-Mix EDID (the LEDs flash in a running sequence)
To store the selected EDID, press EDID READ as described in the following
example.
To cancel the EDID modification wait for a few seconds without touching any button.
Select the EDID from Output 3:
1. Press the EDID SELECT button repeatedly until OUTPUT 3 LED lights.
2. Press the EDID READ button.
When the LED stops flashing the EDID from Output 3 is stored at the input.
Pressing the EDID SELECT button briefly once causes the relevant LEDs to
indicate which EDID is stored at the input, as follows:

OUTPUT 1 LED flashes
—the EDID from OUTPUT 1 was the last acquired

OUTPUT 2 LED flashes
—the EDID from OUTPUT 2 was the last acquired,
and so on

All OUTPUT LEDs flash —the default EDID was the last acquired

All OUTPUT LEDs flash sequentially —the Auto-Mix EDID was the last
acquired
The EDID acquired is a weighted average of all the connected outputs. For example, if
several displays with different resolutions are connected to the outputs, the acquired
EDID supports all the resolutions, as well as other parameters included in the EDID