American Audio DCD-PRO1000 - Manual (Page 28)

PITCH ADJUSTMENTS
© American Audio ® - www.americanaudio.us - DCD-PRO1000™ Instruction Manual Page 28
2. PITCH BENDING:
Unlike the PITCH SLIDER (35
) adjustment t his function will momentarily increase or decrease a tracks
speed during playback. There are two ways to operate this function with the (-) & (+) PITCH BUTTONS (28 &
29) or with the JOG WHEEL (23). The maximum pitch bend percentage allowed is +/- 100%. The pitch bend
function will work in conjunction with the PITCH SLIDER (35) pitch setting. For example, if the PITCH SLIDER
(35) is set to a 2% pitch gain the pitch bending process will begin at 2% and wi
ll continue to the maximum
of + /- 100%.
NOTE: A -100% pitch manipulation will stop playback entirely.
Holding down on the (-) PITCH BEND BUTTON (25) will
provide a slow down in the playback pitch.
Figure 42
Using the Pitch Slider Percentage Selector (27): You may
choose a pitch operating range at any time. To change the oper-
ating range be sure the pitch function is turned on, see figure 40.
The pitch percentage can be changed between +/-4%, +/-8%,
+/-16%, and +/- 100%. 4% will allow the least amount of pitch
manipulation and 100% will allow the most amount of pitch
manipulation. To adjust the different values, press the PITCH
ON/OFF BUTTON (17) and Tap on the % BUTTON (27) until your
desired value is reached. The L.E.D. of the % BUTTON (27);
glowing red for 4%, flashing red for 8%, glowing blue for 16% or
flashing blue for 100%.
Figure 43
Holding down on the (+) PITCH BEND BUTTON (26) will
provide a speed bump in the playback pitch.
Figure 44