Comfort-Aire IR60S - Manual (Page 2)

This electric appliance produces infrared heat, and failure to follow
warnings and instructions can cause a fire, electric shock, or injury.
This heater is designed for outdoor commercial use only.
READ AND SAVE THESE INSTRUCTIONS!
WARNING
FIRE OR EXPLOSION HAZARD
• Failure to follow safety warnings exactly could
result in serious injury or property damage.
• Do not use gasoline or other flammable vapors
or liquids, including aerosol cans, in the vicinity of
this heater while it is operating.
• Do not store or use any of the following flammable
materials on or near the heater, or allow them to
come in contact with the unit: rags, fabric, spray
or aerosol cans, cleaning compounds, plastics
or plastic containers, paper products, gasoline,
kerosene, lighter fluid.
• Do not install the heater close to furniture, curtains
or other flammable items. Allow at least 6 feet
(1.8 meters) between all sides of the heater and
flammable items.
• Do not cover or otherwise obstruct the heater.
• Do not use heater without wire guard in place.
WARNING
PERSONAL INJURY HAZARD
• Do not touch the heater during operation. Burn
or scald injury could result. The casing and
components are extremely hot during operation.
• Keep children away from the heater. Never leave
an unsupervised child near the heater.
• Because of injury risk, the heater should be
operated only by individuals knowledgeable about
the operation and familiar with the warnings and
cautions listed in this manual.
• Because of injury risk, this heater is not intended
for use by persons with reduced physical, sensory
or mental capabilities.
• Heater is not for use in bathrooms, laundry areas
or other locations where unit could fall into a body
of water.
WARNING
PERSONAL INJURY HAZARD–SERVICE
• To avoid property damage, personal injury or death
due to electrical shock, do not service the unit
without first turning the unit OFF and disconnecting
the wired circuits from the main power supply.
• Allow adequate time for the unit to cool down.
• Service must be performed only by a qualfied
service technician.
• Do not use the heater if the power cord is
damaged. Contact an authorized servicer or
qualified electrician to replace the cord prior to use.
• Do not use heater if it has been dropped or dam-
aged in any way, until it has been inspected by an
authorized service facility.
• When cleaning heater or replacing emitter, dis-
connect wired circuits from the power supply. Be
sure heater and/or emitter is cool before handling.
WARNING
INSTALLATION & USE
To avoid property damage, personal injury or death
due to electrical shock, follow all instructions in this
Installation and Operation manual.
• Specified minimum clearances from front, sides,
bottom and back of unit must be met. Failure to
meet clearance minimums can result in fire.
• Heater must be installed by a certified electrican
and must adhere to all local, state and national
electric codes (NEC).
• Heater must be grounded and hard wired.
• Keep the power cable away from body of heater.
Do not use heater if power cord is damaged.
• Do not insert or allow foreign objects to enter any
of the heater openings. Electrical shock could
result.
• Never leave the heater unattended while it is
operating.
Installation & Operation Radiant Infrared Heater Heat Controller
WARNINGS
2