Australian Monitor SY800 - Manual (Page 20)

Distortion
Input Impedance
Input Sensitivity
Input CMRR
(re 4ohm, 1dB below clip
20kohms
)
THD (@ 1kHz) <0.02%
IMD SMPTE (60Hz : 7kHz 4:1) <0.03%
1Vrms
>80dB
Signal/Noise Ratio
Crosstalk
Indicators
Linear >97dB
A-Weighted >104dB
>70dB
Power, Status/Clip (L/R), Overload, Thermal, Fault
20 Specifications
Model:
@ 4 ohms 0.1% THD
Single channel driven
Both channels driven
200W
(2 ohm loads not recommended)
Bridge mode
8 ohm load
400W
(4 ohm bridging not recommended)
28.3
@ 1kHz <0.021ohms
(@ 1kH re 8 ohms) > 375:1
>40 V/µs
@ 1KHz
Rated Power into 4 ohm (-3dB)
SY400
Output Power
Voltage Gain
Output Impedance
Damping factor
Slew rate
Per Channel
240W
15 Hz- 80 kHz
H,W,D = (87 x 482x400) mm
Shipping Weight = 12 Kg
575 VA
Frequency response
Dimensions
Input Power
Model:
@ 4 ohms 0.1% THD
Single channel driven 430
Both channels driven 375W
(2 ohm loads not recommended)
Bridge mode
8 ohm load
750W
(4 ohm bridging not recommended)
38.7
@ 1kHz <0.019 ohms
(@ 1kH re 8 ohms) > 430:1
>40 V/µs
@ 1KHz
Rated Power into 4 ohm (-3dB)
SY800
Output Power
Voltage Gain
Output Impedance
Damping factor
Slew rate
Per Channel
W
15 Hz- 70 kHz
H,W,D = (87 x 482x400) mm
Shipping Weight = 15 Kg
1065 VA
Frequency response
Dimensions
Input Power
Common Specifications
(To all SY Amplifiers)