ATEN CS-104 - Manual (Page 8)

then enter the command keystrokes and complete the command by hitting the [Enter] key.
To start the Auto-Scan mode: (This mode scans all connected computers that are in a power on state,
one- by-one, from the first computer in the first stage, to the last computer in the last stage)
[Alt] [Ctrl] [Shift] + [0] + [Enter]
To stop Auto-Scan mode:
[Space]
To start the Previous/Next mode: (This mode selects from all connected computers that are in a power on
state, one-by-one, from the first computer in the first stage, to the last computer in the last stage)
[Alt] [Ctrl] [Shift] + [9] + [Enter]
To select the previous port:
Left [Shift]
To select the next port:
right [Shift]
To stop the Previous/Next mode:
[Space]
To select a first-stage port directly:
[Alt] [Ctrl] [Shift] + # + [Enter]
(# is the number of the first-stage port)
To select a second-stage port directly:
[Alt] [Ctrl] [Shift] + # + # + [Enter]
( The 1
st
# selects the number of a first-stage port)
( The 2
nd
# selects the number of a second-stage port)
To select a third-stage port directly:
[Alt] [Ctrl] [ Shift] + # + # + # + [Enter]
( The 1
st
# selects the number of a first-stage port)
( The 2
nd
# selects the number of a second-stage port)
( The 3
rd
# selects the number of a third-stage port)
NOTE: # is a numerical digit between [1] and [4]