A&D 191 User Manual

Page 15

With the printer in the setup menu and with
CONFIGURE [NEXT/OK]

CONFIGURE [NEXT/OK]

CONFIGURE [NEXT/OK] as the last item printed, press
OK

OK (right side) to access the CONFIGURE

CONFIGURE

CONFIGURE menu. The

following is printed:

LLLLLOAD DEF

OAD DEF

OAD DEFAUL

AUL

AULTS

TS gives you the opportunity to reset the

printer to all default settings (shown below).

Choose OK

OK to do this or NEXT

NEXT

NEXT to go to the next param-

eter. The following is printed:

Baud rate is the next parameter you can set in the
CONFIGURE

CONFIGURE

CONFIGURE menu. The complete list of parameters and
their possible values is shown below.

The sample list above shows the current baud rate is
2400. To accept this, press OK

OK (right side) or view the

next baud rate value by pressing NEXT

NEXT

NEXT (left side). Press

OK when the baud rate you want is displayed
.

Choose from these baud rates;
300, 600, 1200, 2400, 4800, 9600, or 19200

ATTTTTA BITS

A BITS

A BITS is the next parameter. Choose the data bit

value the same way baud rate was chosen. Choices are 7
or 8 data bits.

Baud Rate

Data Bits

Load Defaults

The complete list
of defaults is
shown in the
Default Table at the
end of this manual.