Installing the x-hd card – Apogee Digital X-HD User Manual

Page 25

APOGEE ELECTRONICS

X-HD card – User’s Guide

Installing the X-HD Card

Your X-HD card should include the following:

1 X-HD circuit board

1 X-HD Coverplate

2 aluminium standoffs

1 plastic standoff

2 screws

1 manual

1 Remove the top cover of the interface
2 Remove the Option Card coverplate and install the X-HD

coverplate using the screws from the original coverplate.

3 Remove the two interface circuit board screws indicated

at left, and set them aside for later use

4 Install the two aluminium standoffs in the threaded holes va-

cated by the screws.

5 Install the plastic standoff in the hole adjacent to the

connector pins of the X-HD card.

6 Insert the Primary/Expansion ports connector end of the

X-HD card through the appropriate cutouts in the coverplate,

and carefully place the X-HD connector pins in the mating

interface connector.

7 After verifying the alignment of the X-HD connector pins

and the interface mating connector, ﬁrmly press down on the

X-HD card, over the connector, until the pins are completely

seated in the mating connector.

8 Secure the Primary/Expansion Port connectors to the

Coverplate by installing the 2 provided screws into the 2 inner
threaded holes

9 Re-install the circuit board screws in the locations indicated

below.

Plastic standoff here