Ariens 991040 - Zoom 2660 HD - Manual (Page 14)

GB - 14
Hour Meter
Records total number of
hours the engine has
been run.
IMPORTANT: Keep a
record of Hour Meter
readings for
recommended Lubrication
and Maintenance
intervals.
NOTE: For accurate readings be sure Ignition
Switch is OFF when unit is not in operation.
FILLING FUEL TANK
Add fuel to Fuel Tank as needed. See your
Engine Manual for correct type and grade of
fuel.
To add fuel to the fuel tank:
1. Place unit in an open or well-ventilated
open area.
2. Stop the engine and allow it to cool.
3. Clean the fuel cap and the area around
the fuel cap to prevent dirt from entering
the fuel tank. Remove the cap from the
fuel tank.
4. Fill the fuel tank to within 1 in. (25 mm)
below bottom of filler neck.
5. Replace fuel cap and tighten.
6. Clean up any spilled fuel.
PRE-START
1. Check Safety Interlock System
If this system does not function as described
do not operate until repairs are made.
2. Check Air Cleaner
Check air filter for dirt. Clean as required.
Follow Engine Manual Maintenance
Schedule.
3. Check Engine Fuel and Crankcase
Oil
Check and add fuel if required. Check that
engine crankcase oil is full. Follow Engine
Manual Maintenance Schedule.
4. Check Tire Pressure
5. Check Hydraulic Fluid Level
6. Adjust Seat
Be sure all controls can be reached safely
from operator’s position.
7. Set Cutting Height
Make sure the deck is set to the correct
cutting height.
STOPPING IN AN EMERGENCY
The unit can be stopped immediately at any
time by turning the ignition key to the "Off"
position.
STARTING AND SHUT OFF
To start the engine:
1. Make sure the steering levers are in
neutral.
2. Put the PTO switch in the “Off” position.
3. Engage parking brake.
4. If the engine is cold, move the choke
control to the “On” position. If the engine
is warm or hot, do not use choke.
5. Move the throttle to 3/4 “Fast” position.
See Engine Manual for detailed
instructions.
6. Put the ignition key in the switch and
turn it to the “Start” position.
7. As soon as the engine starts, release the
key.
8. Move the choke control to the “Off”
position from the “Choke” position. Wait
until the engine is running smoothly
before operation.
To stop the engine:
1. Bring the steering levers to neutral.
Disengage the PTO and engage the
parking brake.
2. Move the throttle lever to the “Slow”
position.
3. Turn the ignition key to the “Off” position.
TO MOW WITH UNIT
Operate the unit only when seated in the
operator’s position.
1. Start the engine. Let the engine warm
until it is running smoothly.
2. Release parking brake.
WARNING: AVOID INJURY.
Read and understand entire
Safety section before proceeding.
CAUTION: Make sure all
hardware is tight, all safety
devices are in place and all
adjustments are made correctly.
CAUTION: Read entire
Owner/Operator Manual, Clutch
Manual, and Engine Manual first.
DO NOT attempt to start engine
at this time.