AT&T 964 - Manual (Page 21)

INTERCOM OPERATION
39
INTERCOM OPERATION
38
This intercom features both a single-phone page and a system-wide page.
A single-phone page alerts only one phone; a system-wide page alerts all
phones. Any phone with the Do Not Disturb (DND) feature activated will
not receive a page.
An intercom call or single-phone page automatically activates the
speakerphone on the receiving phone. You can deactivate the
speakerphone by lifting the handset.
Basic Intercom Operations
INTERCOM Any two stations connected to Line 1 can ring each other.
PAGE Lets you “announce” over the speaker of the phone you’re
calling. The person you’ve called can respond just by
talking.
PAGE * Lets you “announce” to all 964 phones in the system at the
same time (All Page).
CONFERENCE Lets you connect another intercom call with an outside line.
Making an Intercom Call with the Handset
1 Press I and lift the handset. The screen displays:
2 Dial the extension number of the party you wish to reach. If that
extension is idle, you will hear long beeps. If that extension is
busy, you will hear a busy signal. If that extension is set to Do Not
Disturb, you will hear short beeps.
NOTE: The intercom call is automatically cancelled if you do not dial
an extension within 10 seconds.
NOTE: When you direct an intercom call to one extension, any
extension in the system can answer the call.
Use with p
to announce to
all 964 phones
Activate
speakerphone
or headset
Ring another 964 phone
connected to Line 1
Announce
over the
speaker to the
phone you
are calling
– OR -–
Activate Room
Monitor
Deactivate
Auto-Mute to
answer a page
– OR -–
Mute this
phone while
using Room
Monitor
Connect an intercom call
with an outside line, or
connect two calls using
outside lines