Service – Edgecraft Chef's Choice 130 User Manual

Page 12

particles adhered to a magnet attached to the
inside of that cover. Simply rub off or brush
off accumulated filings from the magnet with
a paper towel or tooth brush and reinsert the
cover in the opening. If larger amounts of metal
dust have been created or if the Stage 3 disk
has been cleaned (using the cleaning/dressing
tool) you can shake out any remaining dust
through the bottom opening when the cover
is removed. After cleaning, replace the cover
securely with its magnet in place.

SerVICe

In the event post-warranty service is needed, return your sharpener to the EdgeCraft factory
where the cost of repair can be estimated before the repair is undertaken. Outside the USA,
contact your retailer or national distributor.

Please include your return address, daytime telephone number and a brief description of the

problem or damage on a separate sheet inside the box. Retain a shipping receipt as evidence of
shipment and as your protection against loss in shipment.

Assembled in the U.S.A.

www.chefschoice.com

This product may be covered by one or more EdgeCraft patents and/or patents pending as marked on the product.
Chef’sChoice

, EdgeCraft

, Diamond Hone

, Professional Sharpening Station

and the overall design of this

product are registered trademarks of EdgeCraft Corporation, Avondale, PA.
Conforms to UL Std. 982 Certified to CAN/CSA Std. C22.2 No. 64

Certified to EN 60335-1, EN 60335-2, EN 55014-1+A1, EN 61000-3-2, EN 61000-3-3

Printed in China.

H11 2011-44

C139603

EdgeCraft Corporation

825 Southwood Road, Avondale, PA 19311 U.S.A.

Customer Service (800) 342-3255 or 610-268-0500

Figure 11. Clean-out cover.