Nilfisk-ALTO SCRUBTEC 343E User Manual
Page 48
10
SCRUBTEC 343E
909 6315 000(4)2009-11 A
ENGLISH
USER MANUAL
USE
WARNING!
On some points of the machine there are some adhesive plates indicating:
DANGER
–
WARNING
–
CAUTION
–
CONSULTATION
–
While reading this Manual, the operator must pay particular attention to the symbols shown on the plates.
Do not cover these plates for any reason and immediately replace them if damaged.
BEFORE MACHINE START-UP
Brush or pad-holder installation
NOTE
Use either the brush (42) or the pad-holder (43) according to the type of fl oor to be cleaned.
Insert the positioning pin (24) and disengage the machine transport/parking device (23b).
1.
Lift the brush/pad-holder deck (10) by prying the handlebar (2).
2.
Place the brush (42) or the pad-holder (43) under the deck.
3.
Lower the deck (10) by using the handlebar (2).
4.
Connect the power supply cable (21) to the electrical mains.
5.
Engage the brush/pad-holder by pressing the brush/pad switch (52) for a few seconds.
6.
If the procedure is diffi cult, manually turn the brush/pad-holder counter-clockwise (49).
Brush/pad application guide (suggestions only)
Types of brushes available
Midlite Grit 180
Midgrit 240
Prolite
Union Mix
General cleaning
Concrete
Terrazzo fl oor
Ceramic tiles/quarrystones
Marble
Vinyl tiles
Rubber tiles
Polishing
Rubber tiles
Marble
Vinyl tiles
Squeegee installation
Install the squeegee (11) and fasten it with the handwheels (12), then connect the vacuum hose (22) to the squeegee.
7.
Solution tank fi lling
Open the recovery water tank cover (41) and engage the support rod (59).
8.
Use the fi ller neck (35) to fi ll the tank (27) with a solution suitable for the work to be performed.
9.
Do not fi ll the solution tank completely, leave a few centimetres from the edge.
Always follow the dilution instructions on the label of the chemical product used to prepare the solution.
The solution temperature must not exceed 40°C.
CAUTION!
Use only low-foam and non-fl ammable detergents, intended for automatic scrubber applications.
Adjustments
Adjust the handlebar (2) with the knobs (3) to reach a comfortable position.
10.