Nyrius ARIES Home - Manual (Page 13)

13
TX/RX WILL NOW BE PAIRED :
1. RX (Receiver) : Remove mini USB power adapter, make sure RX is without power.
2. Press Power button and then plug-in mini USB power adapter. (continue holding power button)
3. Release Power button, RX’s Power button LED will now fl ash purple.
Aft er the 3 steps above , you will see the following OSD :
1. TX (Transmitter): Remove TX 5V DC power adapter, make sure TX is without power.
2. Press Power button and then plug-in 5V DC power adapter. (continue holding power button)
3. Release Power button, RX’s Power button LED will now white & Red light.
Aft er the 3 steps above , you will see the following OSD :
NOTE: When pairing NAVS502 you will instead see (Adding NAVS502).
Units will be paired aft er the 6 steps are completed.