beautypg.com

Leaning, Nstructions – Glastender GT-18 User Manual

Page 14

background image

12

Glastender, Inc. • 5400 North Michigan Road • Saginaw, MI • 48604-9780

800.748.0423 • 989.752.4275 • Fax 989.752.4444 • www.glastender.com

c

leaninG

i

nSTrucTionS

Regular maintenance of your Glastender glasswasher will extend its useful life and lower the service costs. The

top section of a GT-18 glasswasher is removable to ease regular maintenance. Also, the following parts are

removable for daily cleaning:

1. Spray Box

2. Splash Guard

3. Pump Inlet Screen

4. Drain Stopper (Overflow hole to rear)

5. Scrap Tray

The daily cleaning procedure consists of the following steps:

1. With machine not operating, remove Spray Box, Spray Box Gasket and Pump Inlet Screen.

2. Remove all debris.

3. Wipe the interior of tank with a damp cloth. For more stubborn soil or stains, you may scrub the interior of

the tank with a Scotch-Brite® pad. Do NOT use steel wool.

4. Rinse the interior with clean water.

5. Rinse and scrub clean the Spray Box, Spray Box Gasket, and Pump Inlet Screen as necessary and reinstall

into machine.

6. Check Detergent, Sanitizer, and Rinse Aid Containers. Refill or replace if empty.

7. Visually inspect the Detergent Inlet after the drain has closed and water begins to fill the tank. You should

notice detergent intermittently dripping. Approximately 85 seconds later, visually inspect the Sanitizer and

Rinse Aid Inlets after the drain has closed and water begins to fill the tank. You should notice sanitizer and

rinse aid intermittently dripping.

8. Your glasswasher is now ready for operation.

When the interior is coated with a white chalky substance, perform the following Deliming Procedure (after daily

cleaning has been completed):

1. Place empty Glass Rack on drive wheel.

2. Push Start Switch.

3. Catch the detergent in a cup and dispose.

4. Pour one cup of deliming agent in the glasswasher. WARNING! Most deliming agents are hazard-

ous. Follow all instructions very carefully!

5. Do not open the door until the cycle is complete.

6. Repeat steps 1 thru 5 if further deliming is necessary.

7. Cycle the glasswasher two or three times.

d

eliminG

p

rocedure