Goulds Pumps ANSI FAMILY IOM (ATEX Compliant) - Manual (Page 22)

2. Spread bottom of coupling guard half (pump end)
slightly and place over pump end plate as shown
in Fig. II-4. The annular groove in the guard half
is located around the end plate (Fig. II-5).
3. After the coupling guard half (pump end) is
located around the end plate, secure it with a bolt,
nut and two (2) washers through the round hole at
the front end of the guard half as shown in Fig.
II-6. Tighten securely (Fig. II-7).
4. Spread bottom of coupling guard half (driver end)
slightly and place over coupling guard half (pump
end) so that annular groove in coupling guard half
(driver end) faces the motor as shown in Fig. II-8.
124
ANSIFAM IOM - 5/08
Fig. II-5
ANNULAR GROOVE
234A
501B
Fig. II-6
Fig. II-4
501B
ANNULAR
GROOVE
DRIVER
234A
Fig. II-7
NUT
WASHER
BOLT
Fig. II-8
ANNULAR
GROOVE
501B
DRIVER