Minka Group F840-CF - Manual (Page 23)

TROUBLESHOOTING 12
SOLUTION
NOTE: All blade sets are grouped
by weight. Because wood and
plastic blades vary in density,
the fan may wobble even
though blades are matched.
SYMPTOM
Fan Wobble
SOLUTION SYMPTOM
Fan Sounds Noisy
SOLUTION
Allow a 24-hour”break
in”period.Most noises
associated with a new
fan will go away during
this time.
Make sure the screws that
attach the fan blade holder
to the motor hub is tight.
Make sure outlet box is
secured to building structure,
if necessary use the wood
screws provided to further
secure outlet box to joist.
Make sure hanger bracket is
secure to the outlet box,
screws are tight.
SYMPTOM
Fans/Light Turn on
and Off
Unexpectedly SYMPTOM
Fan will not strart
Check to make sure the wall
switch is turned on.
Check circuit fuses or breakers.
Caution! Make sure the power is
turned off before performing the
following steps.
Remove canopy and check wire
connections.
Check wall control transmitter
connections ( if applicable).
NOTE: Fan must be installed at a
maximum distance of 40 feet
from the transmitting unit for
proper signal transmission
between the transmitting unit
and the fan’s receiving unit.
Use the balancing kit provided
if the wobble is excessive
(follow i n s t r u c t i o n s i n c l u d e d
w i t h balancing kit)
Make sure outlet box is secured
to building structure, if
necessary use the wood screws
provided to further secure outlet
box to joist
Make sure hanger bracket is
secure to the outlet box, screws
are tight.
This is caused
by interference,
change the code
frequency from
the transmitter,
and follow the
instructions from
Section 5 again
to operate your
transmitter and
fan.
1.
1.
1.
1.
1.
2.
2.
3.
4.
5.
2.
3.
3.
4.
SOLUTION
SYMPTOM
Lights shut off and
will not come back on.
SOLUTION
This unit is equipped
with a wattage limiting
device. Lamping in
excess of 190 watts will
disable your ceiling
fan’s light kit. To reset
your light kit, you must
turn the power off and
re-lamp, keeping the
wattage under 190
watts. Restore power to
your ceiling fan and
continue normal
operation.