Minka Group F905-DK - Manual (Page 18)

10
INSTALLING THE LIGHT BULB & GLASS SHADE
Fig. 17
WARNING: Shut off the power supply before removing or replacing lamp. In handling of
halogen bulb, care should be taken not to touch it with your bare hands. Oil residue will shorten
the life of the halogen bulb. If you accidentally come into contact, wipe thoroughly with a clean,
lint-free, cotton cloth. Allow the bulb to cool off for 10 minutes before changing the bulb. Use
light bulb in accordance with the fan's specification. TO REDUCE THE RISK OF FIRE DO NOT
EXCEED MAXIMUM WATTAGE RATING.
ATTENTION: The Energy Policy Act of 2005 requires this fan to be equipped with a 190 watt
limiting device. If lamping exceeds 190 watts, the ceiling fan's light kit will shut off automatically.
Step 1. Install 100W halogen bulb (included). (Fig. 17).
Note: If you want to install the fan without the glass shade and bulb, please skip this intallation
process and procees to page 11 (Fig.18).
Step 2. Raise glass shade up against bottom of fan housing and secure it to fan by turning it
clockwise until snug. DO NOT OVERTIGHTEN. (Fig. 17)
Light plate
Mounting plate
Glass shade
Blub