Minka Group F648-SWH - Manual (Page 16)

8
Fig. 17
REMEMBER: REMEMBER: To disconnect the power. The fan blades must be already attached to the fan.
ATTENTION: ATTENTION: The Energy Policy Act of 2005 requires this fan to be equipped with a 190 watt
limiting device. If lamping exceeds 190 watts, the ceiling fan's light kit will shut off automatically.
Step 1. Remove and discard the center plug from the switch cup. (Fig. 17)
Step 2. Feed the BLACK and WHITE wires from the light kit through the center hole of the switch
cup. Thread the switch cup to the nipple on the light kit. (Fig. 17) Make sure the light kit is
securely attached to the switch cup to prevent it from vibrating loose during fan operation.
LIGHT KIT INSTALLATION
SWITCH CUP
PLUG
LIGHT KIT
NUT
LOCK WASHER
WIRE NUT