beautypg.com

Light kit installation – Minka Group F647-ORB User Manual

Page 16

background image

8

Fig. 17

REMEMBER:

REMEMBER: To disconnect the power. The fan blades must be already attached to the fan.

ATTENTION:

ATTENTION: The Energy Policy Act of 2005 requires this fan to be equipped with a 190 watt
limiting device. If lamping exceeds 190 watts, the ceiling fan's light kit will shut off automatically.

Step 1. Remove the screws from the light kit mounting plate. While holding the light kit, firmly snap

the wire molexes together. Next, slide light kit up against the mounting plate and rotate it
until the screw holes are aligned. Secure light kit to the mounting plate using the screws
removed earlier. (Fig. 17) CAUTION:

CAUTION: Make sure that the wires are not pinched between the

switch cup and the switch cup plate.

LIGHT KIT

LIGHT KIT

MOUNTING PLATE

CONECTOR

SCREWS

LIGHT KIT INSTALLATION

This manual is related to the following products: