Minka Group F544-BCW - Manual (Page 15)

6
Use light bulb in accordance with the fan's specifications. DO NOT
EXCEED THE MAXIMUM WATTAGE RATING.
Step 1. Remove 1 of the 3 screws from the lamp holder plate and
loosen the other 2 (do not remove). (Fig. 9)
Step 2. Snap the connector plugs from the fan and light kit. Place
the light kit plate over the two screws previously loosened (via the
two key holes) and turn until it locks into place. Install the 3rd
screw previously removed and securely tighten all three screws.
(Fig. 9)
Step 3. Install 2-60W candelabra bulbs (included). (Fig. 10)
Step 4. Remove the finial, hex nut and washer from the threaded
nipple. (Fig. 10).
Step 5. Install the glass shade and secure with the the cap & the
washers, nut and finial previously removed. (Fig. 11)
INSTALLING THE LIGHT KIT & GLASS SHADE