Minka Group F566-WH - Manual (Page 4)

I
NSTALLING THE
F
AN
Tools Required: Phillips screw driver; slotted screw driver; step-ladder; wire cutters;
electrical tape.
M
OUNTING
O
PTIONS
If there isn't an existing mounting box,
then read the following instructions.
Disconnect the power by removing Disconnect the power by removing
fuses or turning off circuit breakers. fuses or turning off circuit breakers.
Secure the outlet box directly to the
building structure. Use appropriate
fasteners and building materials. The
outlet box and its support must be able
to fully support the moving weight of
the fan (at least 50 lbs.). Use a UL Use a UL
Listed metal outlet box. Do not use a Listed metal outlet box. Do not use a
plastic outlet box. plastic outlet box.
Figure 1, 2 and 3 are examples of
different ways to mount the outlet box.
To hang your fan where there is an
existing fixture but no ceiling joist, you
may need to install a hanger bar as
shown in Fig. 4 (available at your
Minka-Aire Minka-Aire TM TM dealer).
FIG. 1
FIG. 3
FIG. 2
CROSS BRACE
CEILING
JOIST
CEILING
JOIST
CEILING
JOIST
OUTLET BOX
PARALLEL WOOD BRACE
(Min. 2" Thick)
OUTLET
BOX
OUTLET BOX
CEILING JOIST OR
CROSS BRACE
HANGER BAR
(OPTIONAL)
MOUNTING
BRACKET