Team Associated ProRally - Manual (Page 30)

30
:: Trouble Shooting
Solution
Charge battery.
Plug in battery.
Reset speed control using
your instruction manual.
Re-bind transmitter to the receiver.
Plug in motor.
Reset speed control using your
instruction manual.
Replace motor.
Plug servo in.
Free up steering linkage.
Replace servo.
Switch any two motor wires.
Check throttle reversing switches
on transmitter. Reset speed
control.
Check steering reversing switches
on transmitter.
Check for loose wires or check for
or dead radio batteries.
Radio interference.
Check that reverse mode has not
been turned off. Refer to speed
control instructions. Reset speed
control, or send in for repair.
Let speed control cool off. Check
gear, gear mesh, or bind in driveline.
Let motor cool and check
recommended gearing for motor
type.
Reset gear mesh (see instruction
manual).
LiPo mode on the ESC has
engaged, recharge your batteries.
(If running NiMH battery, turn off
LiPo mode)
Description
No Power
No Throttle
No Steering
Throttle
Steering
Vehicle is
glitching
Reverse
Vehicle dies
or slows
Problem
Battery is discharged...........
Battery not plugged in.........
No light on speed control....
Receiver LED remains red.
Motor not plugged in............
Speed control out of ............
adjustment.
Motor failure............................
Servo not plugged in.............
Locked up steering linkage.
Servo failure.............................
Goes backwards when you
pull the trigger, or forward
when pushing brakes /
reverse.
Goes right when turning......
the wheel left (or left when
turned right.)
Vehicle has a problem on.....
power.
No reverse or brakes...........
Speed control overheats....
Motor overheats...................
Gear mesh set too tight......
LiPo mode engages...............