Team Associated RC10 - Manual (Page 13)

13
:: Shocks Build - Bag G-GG - Step 2
:: Shocks Build - Bag G-GG - Step 3
:: Shocks Build - Bag G-GG - Step 4
5407
Red O-ring
(use for
rear shocks
only)
5407
Red
O-ring
7484
Shock
Bottom
Cap
6468
Shock
Pivot Ball
7484
Shock
Internal
Spacer
7438
V2 .71
Threaded
Body (front)
7481
V2 1.32
Threaded
Body (rear)
6471
Shock
Rod End
4187
Nylon
Spacers
x2
6469
Shock cap
o-ring
Build x2 front and x2 rear shocks
Step 8 Step 9-10 Step 6-7 Step 4-5
Front: 0
Rear: 3
Step 2-3
7416
Threaded
Shock Collar
3959
Shock Collar
O-Ring
6496
Front shock
spring, silver
(3.85lb)
6478
Rear shock
spring, silver
(2.10lb)
Build x2 front and x2 rear shocks
Front:
5mm
Rear:
1mm
Shock fluid
35wt #5429
Shock fluid
35wt #5429
6428
Shock
cap
(molded)
9645
2-56 x 1/8”
BHCS
Slow
Racer’s Tip:
Use your finger to rub shock
oil on the o-ring for smoother
adjustment!
6475
Shock Cups
(rear)
9724
Offset
Shock Cups
(front)
* Shock Bleeding Steps:
1. Before assembly, get each bleed
screw and thread it 1-2 turns into
the shock cap. This will make
installation easier when you are
bleeding your shocks.
2. Pull shock shaft down.
3. Fill shock body 3/4 full with silicone fluid.
4. Slowly move the shock shaft up and
down to remove air from under piston.
5. Wait for bubbles to come to surface
6. Fill shock body to top with silicone fluid
7. Place a drop of oil in the cap and on cap
thread
8. Install cap (without bleed screw) and
tighten completely
9. Slowly compress shaft all the way to
bleed excess silicone fluid out the hole
in the cap (use rag around shock to
catch excess fluid)
10. Install 2-56 button head screw until
snug while shaft is fully compressed
(recommend using a high quality .050”
wrench such as Factory Team #1542)