Dynalab SB3/120V/60 - Manual (Page 5)

3
given above. Then switch the unit OFF by
pressing in the control knob. Wait 5 seconds and
switch the unit back ON by pressing the control
knob in. The inputted values are now saved in
the memory. They can be altered at any time by
following the same procedure.
Maintenance & servicing
WARNING: Ensure the unit is disconnected
from the mains electricity supply before
attempting maintenance or servicing.
Periodically clean the instrument using a damp
cloth and mild detergent solution. Do not use
harsh or abrasive cleaning agents.
Any repairs or replacement of parts MUST be
undertaken by suitably qualified personnel.
For a comprehensive list of parts required by
service engineers conducting internal repairs and
a service manual, please contact the Technical
Service Department of Barloworld Scientific Ltd.
quoting both the model and serial number.
Only spare parts supplied or specified by
Barloworld Scientific Ltd. or its agents should be
used. Fitting of non-approved parts may affect
the performance and safety features designed
into the instrument.
Technical specification
SB2 SB3
Speed Fixed - 20 rpm Variable - 2 to 40 rpm
Speed display None Digital
Timer No Yes – up to 999mins
Dimensions (w x d x h) 200 x 270 x 240 mm 200 x 270 x 240 mm
Weight 3.2 Kg 3.2 Kg
Electrical supply 230V / 50Hz, 50W 230V / 50Hz, 50W
If in any doubt, please contact the Technical
Service Department of Barloworld Scientific Ltd.
or the point of sale.
Barloworld Scientific Ltd.
Stone, Staffordshire ST15 0SA
United Kingdom
Tel: +44 (0) 1785 812121
Fax: +44 (0) 1785 813748
e-mail [email protected]
www.barloworld-scientific.com
Warranty
Barloworld Scientific Ltd warrants this instrument
to be free from defects in material and
workmanship, when used under normal
laboratory conditions, for a period of three (3)
years. In the event of a justified claim, Barloworld
Scientific will replace any defective component or
replace the unit free of charge.
This warranty does NOT apply if damage is
caused by fire, accident, misuse, neglect,
incorrect adjustment or repair, damage caused by
incorrect installation, adaptation, modification,
fitting of non approved parts or repair by
unauthorised personnel.