MEGUIAR'S D120 - Manual (Page 5)

D120, Glass Cleaner Concentrate (22-134A): D12001, D12005, D12025
__________________________________________________________________________________________
Page: 5 of 15
Contain spill. Cover spill area with a fire-extinguishing foam designed for use on solvents, such as alcohols and acetone, that
can dissolve in water. An AR-AFFF type foam is recommended. Working from around the edges of the spill inward, cover
with bentonite, vermiculite, or commercially available inorganic absorbent material. Mix in sufficient absorbent until it
appears dry. Remember, adding an absorbent material does not remove a physical, health, or environmental hazard. Collect
as much of the spilled material as possible using non-sparking tools. Place in a metal container approved for transportation
by appropriate authorities. Clean up residue with water. Seal the container. Dispose of collected material as soon as
possible.
6.4. Reference to other sections
Refer to Section 8 and Section 13 for more information
SECTION 7: Handling and storage
7.1. Precautions for safe handling
Keep out of reach of children. Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Ground/bond container
and receiving equipment. Use only non-sparking tools. Take precautionary measures against static discharge. Do not
breathe dust/fume/gas/mist/vapours/spray. Do not get in eyes, on skin, or on clothing. Do not eat, drink or smoke when
using this product. Wash thoroughly after handling. Avoid contact with oxidising agents (eg. chlorine, chromic acid etc.)
Wear low static or properly grounded shoes. To minimize the risk of ignition, determine applicable electrical classifications
for the process using this product and select specific local exhaust ventilation equipment to avoid flammable vapor
accumulation.
7.2. Conditions for safe storage including any incompatibilities
Store in a well-ventilated place. Keep cool. Keep container tightly closed. Store away from heat. Store away from acids.
Store away from oxidising agents.
7.3. Specific end use(s)
See information in Section 7.1 and 7.2 for handling and storage recommendations. See Section 8 for exposure controls and
personal protection recommendations.
SECTION 8: Exposure controls/personal protection
8.1 Control parameters
Occupational exposure limits
Ingredient CAS Nbr Agency Limit type Additional comments
2-Butoxyethanol 111-76-2 Health and
Safety Comm.
(UK) TWA:123 mg/m3(25
ppm);STEL:246 mg/m3(50
ppm) Skin Notation
Propan-2-ol 67-63-0 Health and
Safety Comm.
(UK) TWA:999 mg/m³(400
ppm);STEL:1250 mg/m³(500
ppm)
Health and Safety Comm. (UK) : UK Health and Safety Commission
TWA: Time-Weighted-Average
STEL: Short Term Exposure Limit
CEIL: Ceiling
Biological limit values
Ingredient CAS
Nbr Agency Determinant Biological
Specimen
Sampling
Time Value Additional
comments
2-Butoxyethanol 111-76-
2 UK EH40
BMGVs Butoxyacetic
acid Creatinine in
urine EOS 240 mmol/mol
UK EH40 BMGVs : UK. EH40 Biological Monitoring Guidance Values (BMGVs)
EOS: End of shift.