MEGUIAR'S M85 User Manual
Page 5

M85, Diamond Cut Compound 2.0 (21-97A): M8501, M8532
__________________________________________________________________________________________
Page: 5 of 17
8.2.1. Engineering controls
Use general dilution ventilation and/or local exhaust ventilation to control airborne exposures to below relevant Exposure
Limits and/or control dust/fume/gas/mist/vapours/spray. If ventilation is not adequate, use respiratory protection equipment.
8.2.2. Personal protective equipment (PPE)
Eye/face protection
The following eye protection(s) are recommended: Safety glasses with side shields.
Skin/hand protection
Gloves made from the following material(s) are recommended: Nitrile rubber.
Polymer laminate
Respiratory protection
Select one of the following approved respirators based on airborne concentration of contaminants and in accordance with
regulations:
Half facepiece air-purifying respirator suitable for organic vapors/acid gases and particulates
SECTION 9: Physical and chemical properties
9.1. Information on basic physical and chemical properties
Physical state
Liquid.
Appearance/Odour
Sweet hydrocarbon odour; White, creamy viscous lotion
pH
8 - 8.8
Boiling point/boiling range
193.3 ºC
Melting point
Not applicable.
Flammability (solid, gas)
Not classified
Explosive properties
Not classified
Oxidising properties
Not classified
Flash point
> 93.3 ºC [Test Method:Closed Cup]
Autoignition temperature
Not applicable.
Flammable Limits(LEL)
Not applicable.
Flammable Limits(UEL)
Not applicable.
Vapour pressure
No data available.
Relative density
1.00 [Ref Std:WATER=1]
Water solubility
Moderate
Partition coefficient: n-octanol/water
No data available.
Evaporation rate
No data available.
Vapour density
> 1
Viscosity
25 - 40 Pa-s
Density
1 g/cm3
9.2. Other information
Volatile organic compounds (VOC)
16.9 % weight
VOC less H2O & exempt solvents
520.73 g/l
SECTION 10: Stability and reactivity