MEGUIAR'S M85 - Manual (Page 4)

M85, Diamond Cut Compound 2.0 (21-97A): M8501, M8532
__________________________________________________________________________________________
Page: 4 of 17
exhaust vapours, in accordance with good industrial hygiene practice. Warning: A motor could be an ignition source and
could cause flammable gases or vapours in the spill area to burn or explode.
6.2. Environmental precautions
Avoid release to the environment.
6.3. Methods and material for containment and cleaning up
Contain spill. Working from around the edges of the spill inward, cover with bentonite, vermiculite, or commercially
available inorganic absorbent material. Mix in sufficient absorbent until it appears dry. Remember, adding an absorbent
material does not remove a toxic, corrosivity or flammability hazard. Collect as much of the spilled material as possible.
Clean up residue with detergent and water. Place in a closed container approved for transportation by appropriate authorities.
Seal the container. Dispose of collected material as soon as possible.
6.4. Reference to other sections
Refer to Section 8 and Section 13 for more information
SECTION 7: Handling and storage
7.1. Precautions for safe handling
Keep out of reach of children. Do not get in eyes, on skin, or on clothing. Do not breathe dust/fume/gas/mist/vapours/spray.
Avoid breathing of dust created by cutting, sanding, grinding or machining. Do not eat, drink or smoke when using this
product. Avoid contact with oxidising agents (eg. chlorine, chromic acid etc.) Wash thoroughly after handling.
7.2. Conditions for safe storage including any incompatibilities
Store away from acids. Store away from heat. Store away from oxidising agents. Store away from strong bases.
7.3. Specific end use(s)
See information in Section 7.1 and 7.2 for handling and storage recommendations. See Section 8 for exposure controls and
personal protection recommendations.
SECTION 8: Exposure controls/personal protection
8.1 Control parameters
Occupational exposure limits
Ingredient CAS Nbr Agency Limit type Additional comments
Morpholine 110-91-8 Health and
Safety Comm.
(UK) TWA: 36 mg/m³ (10 ppm);
STEL: 72 mg/m³ (20 ppm) Skin Notation
Aluminium oxide 1344-28-1 Health and
Safety Comm.
(UK) TWA(as inhalable dust):10
mg/m³;TWA(as respirable
dust):4 mg/m³
Glycerin 56-81-5 Health and
Safety Comm.
(UK) TWA(as mist):10 mg/m3
Naphtha (petroleum),
hydrotreated heavy 64742-48-9 Manufacturer
determined
TWA:100 ppm
Health and Safety Comm. (UK) : UK Health and Safety Commission
TWA: Time-Weighted-Average
STEL: Short Term Exposure Limit
ppm: parts per million
mg/m³: milligrams per cubic metre
CEIL: Ceiling
8.2. Exposure controls