MEGUIAR'S M87 - Manual (Page 5)

M87, Mirror Glaze High Temp Mold Release Wax (Original Formula): M8711
__________________________________________________________________________________________
Page: 5 of 13
SECTION 6: Accidental release measures
6.1. Personal precautions, protective equipment and emergency procedures
Evacuate area. Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Use only non-sparking tools. Ventilate
the area with fresh air. Refer to other sections of this SDS for information regarding physical and health hazards, respiratory
protection, ventilation, and personal protective equipment.
6.2. Environmental precautions
Avoid release to the environment.
6.3. Methods and material for containment and cleaning up
Contain spill. Working from around the edges of the spill inward, cover with bentonite, vermiculite, or commercially
available inorganic absorbent material. Mix in sufficient absorbent until it appears dry. Collect as much of the spilled
material as possible using non-sparking tools. Place in a metal container approved for transportation by appropriate
authorities. Clean up residue. Seal the container. Dispose of collected material as soon as possible.
6.4. Reference to other sections
Refer to Section 8 and Section 13 for more information
SECTION 7: Handling and storage
7.1. Precautions for safe handling
Do not use in a confined area with minimal air exchange. Keep out of reach of children. Keep away from heat/sparks/open
flames/hot surfaces. - No smoking. Avoid breathing dust/fume/gas/mist/vapours/spray. Do not get in eyes, on skin, or on
clothing. Do not eat, drink or smoke when using this product. Wash thoroughly after handling. Avoid contact with oxidising
agents (eg. chlorine, chromic acid etc.) Wear low static or properly grounded shoes. To minimize the risk of ignition,
determine applicable electrical classifications for the process using this product and select specific local exhaust ventilation
equipment to avoid flammable vapor accumulation. Ground/bond container and receiving equipment if there is potential for
static electricity accumulation during transfer.
7.2. Conditions for safe storage including any incompatibilities
Store in a well-ventilated place. Keep container tightly closed. Keep cool. Store away from heat. Store away from acids.
Store away from strong bases. Store away from oxidising agents.
7.3. Specific end use(s)
See information in Section 7.1 and 7.2 for handling and storage recommendations. See Section 8 for exposure controls and
personal protection recommendations.
SECTION 8: Exposure controls/personal protection
8.1 Control parameters
Occupational exposure limits
If a component is disclosed in section 3 but does not appear in the table below, an occupational exposure limit is not available
for the component.
Ingredient CAS Nbr Agency Limit type Additional comments
NUC - Naphthol Spirits 64742-48-9 Manufacturer
determined
TWA:100 ppm
UK HSC : UK Health and Safety Commission
TWA: Time-Weighted-Average
STEL: Short Term Exposure Limit
CEIL: Ceiling
Biological limit values
No biological limit values exist for any of the components listed in Section 3 of this safety data sheet.