MEGUIAR'S MV80 - Manual (Page 4)

MV80 - Velocity Speed Cut Mold Compound
Hand protection
Exposure controls
A respirator is not needed under normal and intended conditions of product use.
Use latex gloves.
Safety glasses. Goggles, face shield, or other full-face protection if potential exists for direct
exposure to aerosols or splashes. Eye protection
Respiratory protection
Diethylene Glycol Ether Nationale MAC-lijst (Netherlands, 2001). Skin Notes: Legal
TGG: 180 mg/m
3 8 hour(s).
TGG: 32 ppm 8 hour(s).
:
:
:
Netherlands
Spain
Crystalline Silica INSHT (Spain, 2003). Notes:
TWA: 0.1 mg/m
3 8 hour(s).
Provide exhaust ventilation or other engineering controls to keep the airborne concentrations of
vapours below their respective occupational exposure limits. Ensure that eyewash stations
and safety showers are close to the workstation location. Occupational exposure
controls :
Skin protection Additional body garments should be used based upon the task being performed (e.g.,
sleevelets, apron, gauntlets, disposable suits). :
202°C (395.6°F)
Physical and chemical properties
Physical state
Boiling point
Vapour pressure
Relative density
Vapour density
Solubility
Liquid.
1.02 g/cm 3
>1 (Air = 1)
The highest known value is <0.01 kPa (<0.1 mm Hg) (at 20°C) (Isoparaffinic hydrocarbon).
Easily soluble in methanol, acetone.
Partially soluble in cold water, hot water.
Hydrocarbon. Odour
pH
Brownish-red. Colour
Evaporation Rate <1 compared to Butyl acetate.
Auto-ignition temperature
Flash point
The lowest known value is 204.49°C (400.1°F) (Diethylene Glycol Ether).
Closed cup: Higher than 93.3°C (200°F). (Pensky-Martens.)
Risks of explosion of the product in presence of mechanical impact: Not available.
Risks of explosion of the product in presence of static discharge: Not available.
9.
5.5 [Acidic.]
Explosive properties
:
:
:
:
:
:
:
:
:
:
:
:
:
Not applicable Oxidising properties :
General information
Appearance
Important health, safety and environmental information
Other information
VOC Content : 7% (v/v).
Hazardous Decomposition
Products
Stability and reactivity
These products are carbon oxides (CO, CO
2
). Some metallic oxides.
The product is stable. Stability
10.
Reactive with oxidizing agents.
:
:
Materials to avoid :
Date of issue : Page: 4/7 March 31, 2004.