MEGUIAR'S MV83 - Manual (Page 6)

MV83, Velocity Liquid Mold Sealer (XP4-57A): MV8301
__________________________________________________________________________________________
Page: 6 of 19
Oxidising properties Not classified
Flash point 40.6 ºC [Test Method:Pensky-Martens Closed Cup]
[Details:D93-90]
Autoignition temperature No data available.
Flammable Limits(LEL) No data available.
Flammable Limits(UEL) No data available.
Vapour pressure No data available.
Relative density 0.75 [Ref Std:WATER=1]
Water solubility No data available.
Partition coefficient: n-octanol/water No data available.
Evaporation rate No data available.
Vapour density No data available.
Viscosity 1.5 mm²/sec [@ 25 ºC ]
Viscosity 1.2 mm²/sec [@ 40 ºC ]
Density 0.75 g/cm3
9.2. Other information
Volatile organic compounds (VOC) 99.02 % weight
VOC less H2O & exempt solvents 742.64 g/l
SECTION 10: Stability and reactivity
10.1 Reactivity
This material may be reactive with certain agents under certain conditions - see the remaining headings in this section
10.2 Chemical stability
Stable.
10.3 Possibility of hazardous reactions
Hazardous polymerisation will not occur.
10.4 Conditions to avoid
Heat.
Sparks and/or flames.
10.5 Incompatible materials
Strong oxidising agents.
Strong acids.
Strong bases.
10.6 Hazardous decomposition products
Substance Condition
None known.
SECTION 11: Toxicological information
The information below may not be consistent with the material classification in Section 2 if specific ingredient
classifications are mandated by a competent authority. In addition, toxicological data on ingredients may not be
reflected in the material classification and/or the signs and symptoms of exposure, because an ingredient may be
present below the threshold for labelling, an ingredient may not be available for exposure, or the data may not be