beautypg.com

MEGUIAR'S MV83 User Manual

Page 5

background image

MV83, Velocity Liquid Mold Sealer (XP4-57A): MV8301

__________________________________________________________________________________________

Page: 5 of 19

Occupational exposure limits

Ingredient

CAS Nbr

Agency

Limit type

Additional comments

Ethylbenzene

100-41-4

Health and
Safety Comm.
(UK)

TWA:441 mg/m3(100
ppm);STEL:552 mg/m3(125
ppm)

Skin Notation

Toluene

108-88-3

Health and
Safety Comm.
(UK)

TWA: 191 mg/m³ (50 ppm);
STEL: 384 mg/m³ (100 ppm)

Skin Notation

Naphtha (petroleum),
hydrotreated heavy

64742-48-9 Manufacturer

determined

TWA:100 ppm

Health and Safety Comm. (UK) : UK Health and Safety Commission
TWA: Time-Weighted-Average
STEL: Short Term Exposure Limit
ppm: parts per million
mg/m³: milligrams per cubic metre
CEIL: Ceiling

8.2. Exposure controls

8.2.1. Engineering controls
Use explosion-proof ventilation equipment. Use general dilution ventilation and/or local exhaust ventilation to control
airborne exposures to below relevant Exposure Limits and/or control dust/fume/gas/mist/vapours/spray. If ventilation is not
adequate, use respiratory protection equipment.

8.2.2. Personal protective equipment (PPE)

Eye/face protection

As a good industrial hygiene practice:

Wear eye/face protection.

The following eye protection(s) are recommended: Safety glasses with side shields.

Skin/hand protection

Wear protective gloves.
Gloves made from the following material(s) are recommended: Nitrile rubber.

Respiratory protection

In case of inadequate ventilation wear respiratory protection.
Select one of the following approved respirators based on airborne concentration of contaminants and in accordance with
regulations:
Half facepiece or full facepiece air-purifying respirator suitable for organic vapours

SECTION 9: Physical and chemical properties

9.1. Information on basic physical and chemical properties

Physical state

Liquid.

Appearance/Odour

Odourless; Clear liquid

pH

Not applicable.

Boiling point/boiling range

76.7 ºC

Melting point

Not applicable.

Flammability (solid, gas)

Flammable liquid: Category 3.

Explosive properties

Not classified