beautypg.com

MEGUIAR'S MV84 User Manual

Page 6

background image

MV84, Velocity Liquid Mold Release (XP4-57C): MV8401

__________________________________________________________________________________________

Page: 6 of 17

7.1. Precautions for safe handling
For industrial or professional use only. Do not use in a confined area with minimal air exchange. Do not handle until all
safety precautions have been read and understood. Keep away from heat/sparks/open flames/hot surfaces. - No smoking.
Ground/bond container and receiving equipment. Use only non-sparking tools. Take precautionary measures against static
discharge. Avoid breathing dust/fume/gas/mist/vapours/spray. Do not get in eyes, on skin, or on clothing. Do not eat, drink
or smoke when using this product. Wash thoroughly after handling. Avoid contact with oxidising agents (eg. chlorine,
chromic acid etc.) Wear low static or properly grounded shoes. Use personal protective equipment (eg. gloves,
respirators…) as required. To minimize the risk of ignition, determine applicable electrical classifications for the process
using this product and select specific local exhaust ventilation equipment to avoid flammable vapor accumulation.

7.2. Conditions for safe storage including any incompatibilities
Store in a well-ventilated place. Keep cool. Keep container tightly closed. Store away from heat. Store away from acids.
Store away from strong bases. Store away from oxidising agents.

7.3. Specific end use(s)
See information in Section 7.1 and 7.2 for handling and storage recommendations. See Section 8 for exposure controls and
personal protection recommendations.

SECTION 8: Exposure controls/personal protection

8.1 Control parameters

Occupational exposure limits

Ingredient

CAS Nbr

Agency

Limit type

Additional comments

Ethylbenzene

100-41-4

Health and
Safety Comm.
(UK)

TWA:441 mg/m3(100
ppm);STEL:552 mg/m3(125
ppm)

Skin Notation

Toluene

108-88-3

Health and
Safety Comm.
(UK)

TWA: 191 mg/m³ (50 ppm);
STEL: 384 mg/m³ (100 ppm)

Skin Notation

Naphtha (petroleum),
hydrotreated heavy

64742-48-9 Manufacturer

determined

TWA:100 ppm

Health and Safety Comm. (UK) : UK Health and Safety Commission
TWA: Time-Weighted-Average
STEL: Short Term Exposure Limit
CEIL: Ceiling

8.2. Exposure controls

8.2.1. Engineering controls
Use general dilution ventilation and/or local exhaust ventilation to control airborne exposures to below relevant Exposure
Limits and/or control dust/fume/gas/mist/vapours/spray. If ventilation is not adequate, use respiratory protection equipment.
Use explosion-proof ventilation equipment.

8.2.2. Personal protective equipment (PPE)

Eye/face protection

Select and use eye/face protection to prevent contact based on the results of an exposure assessment. The following eye/face
protection(s) are recommended:
Indirect vented goggles.

Skin/hand protection
Select and use gloves and/or protective clothing approved to relevant local standards to prevent skin contact based on the