Myron L 767 User Manual
Page 6
SECTION 2
Installation
2.1 GENERAL
This section provides the recommended procedures for properly
installing the 750/760 Series Conductivity Monitors and cells.
WARNING!
The Myron L Company recommends that all mounting and
electrical installation procedures be performed by trained and
authorized personnel ONLY! Failure to do so could result in
personal injury or loss of life. In addition, damage to the
equipment and/or property may occur.
2.2 MECHANICAL INSTALLATION
All Monitor electronics are packaged inside drip/weather-proof
housings. The physical dimensions of both small and large
housings are suitable for panel, bench or surface mounting.
There are three basic guidelines to consider when selecting a
Monitor’s mounting location:
STEP 1 Select a site that limits the Monitor’s exposure to
excessive moisture and corrosive fumes.
STEP 2 For best results, position your control area as close as
possible to the point(s) being controlled.
4