Rhin-O-Tuff 3250CL - Manual (Page 9)

Troubleshooting
Symptom Solution
Machine will not punch
holes in paper •Plug power cord into wall outlet
•Check wall outlet has power
•Switch machine power switch to
the “on” position
Holes punch on
the edge of paper
•Clear paper chips from the throat
of the punch die
•Seat paper completely into the
bottom of the punch die
Holes punch off center
of page
•Move paper to the left, against the
paper stop, prior to pressing the
punch button
Punch will not punch
through completely
•Only punch 25 sheets of 20lb copy
paper at one time and only 2
sheets of plastic at one time
Punch has stopped
with punch pins still in
the paper and will
not retract on its own
•Turn machine power switch to the “off”
position and unplug power cord from
the wall.
Remove the black cap from the right
side plate of the machine.
Use a flat blade, standard screwdriver
to rotate the shaft counter-clockwise.
This will manually retract the punch pins
from the paper, continue until all pins
have retracted completely.
8
•Remove a couple of sheets from the
back side of the lift of paper and press
the punch button again