NaceCare Solutions ST50BT - Manual (Page 14)

14
MAINTENANCE OPERATIONS
ADJUSTING THE SIDE BRUSH
Figure 20
To adjust the brush height, regulate the screw (a) placed inside the brush bearing
bracket (b).
The brush should be pressed on the floor for about 2 cm.
ADJUSTING THE CENTRAL BRUSH
Figure 21
The central brush should work pressed on the floor for about 7/8 mm. To adjust its
height, regulate the two register screws (a) and (b) on both sides of the machine.
Adjusting the central brush make sure to keep it aligned.
ENGINE MAINTENANCE
Keep scrupulously to the engine maintenance guidelines given in the
engine’s specific OPERATING AND MAINTENACE BOOKLET.
MAINTENANCE PROCEDURES REQUIRING THE INTERVENTION OF PROFESSIONALS
For the following maintenance procedures we invite you to ask for assistance to our
Customer Service, organised in co-operation with our agents, since these procedures
require a specific technical competence and appropriate equipment.
• Replacing the central brush.
• Replacing the side brush.
• Replacing
the belts.