NaceCare Solutions ST40BT - Manual (Page 2)

OVERVIEW
Quick, extremely manoeuvrable and yet capable of handling large areas, the ST 40BT is an
excellent choice for retail, health care, education, hospitality, casinos and office
environments. Its low 62 dB noise level allows for day-time cleaning and the 9 brush
settings make it capable of cleaning virtually any surface including all types of hard floors
along with carpet and textured flooring.
GENERAL PRECAUTIONS
The battery supplied with this unit is a sealed lead acid (SLA) battery that requires no
maintenance.
Do not attempt to open the battery at any time as it will damage the battery.
Do not use this machine in the presence of flammable liquids or gasses.
Do not use this machine on wet surfaces
Do not attempt to pick up toxic materials, oils, or chemicals.
Do not pick up lighted cigarette ends or any other material that could cause combustion of
debris inside of the hopper.
Minimum working temperature: -20°C (-4°F)
Maximum working temperature: +40°C (+104°F)
UNPACKING AND SETUP OF THE MACHINE
1. Remove the packing material and set the machine on the floor.
2. Open the debris hopper located in the rear of the machine and you will find the side broom
inside.
3. Unscrew the bolt and washers from the bottom side of the gear motor shaft and assemble the
side broom to the gear motor as indicated below. The bolt should be hand tight plus ¼ turn
with a wrench.