Maintenance, Technical specifications – NaceCare Solutions AV4X User Manual
Page 4

4
MAINTENANCE
After Every Use
1) Pour out any excess solution from the solution tank
2) Put some fresh water in the solution tank and pump this through the system. This will help keep
the pump system clean.
3) Clean the recovery dome and gasket.
4) Clean any lint or debris from the vacuum inlet screen inside the recovery dome.
5) Thoroughly rinse and drain the recovery tank to prevent odours from developing.
6) Run the vacuum motor for 1 to 2 minutes. This will help remove any moisture from the motor
fans and fan casing.
7) Clean the bottom of the vacuum shoe, removing any lint or debris.
Periodically
1) Inspect power cord and plug for damage.
2) Flush the pump system with an acidic de-calcifying solution to remove deposits.
3) Check the spray jet water dispersion pattern. Clean or replace jets if pattern is erratic.
4) Check & clean the water inlet filter in the solution tank.
TECHNICAL SPECIFICATIONS
Power
115V, 50/60Hz
Consumption
9 amps
Solution Capacity
4 gallons
Recovery Capacity
4 gallons
Pump Pressure
60 psi (max.)
Pump Type
solenoid, with bypass
Water Volume
0 – 0.4 gpm (max.)
Cleaning Width
10 1/2 inches
Vacuum Motor
2 stage, bypass
1,000W, 1.3 Hp
Airflow
106 cfm (max.)
Waterlift
100 inches (max.)
Power Cord
33’
Weight
29 lbs.
WARNINGS
Do not use for any potentially hazardous or health endangering material recovery.
Do not use the machine in corrosive or flammable environments.
Servicing
Only qualified personnel should perform service on this product. This machine is fitted with a grounded
power cord. Only use with a properly grounded electrical outlet. Always use the appropriate parts when
making any repairs. Failure to do so may compromise the safety of the product.
Always use genuine NACECARE SOLUTIONS parts for any repairs required.
1205 Britannia Rd. E., Mississauga, Ontario, Canada L4W 1C4
Tel: (905) 795-0122
Fax: (905) 795-0038
Toll Free Tel: 1-800-387-3210
Toll Free Fax: 1-800-709-2896