MIPRO MT-801a Bodypack Transmitter - Manual (Page 3)

1. Powered-On:
RF signal LED indicator of the receiver
illuminates. .
2. After Powered-On:
The number of illuminated LEDs will increase
as the signal strength increases. If only the
red LED illuminates this indicates abnormal
receiving status.
3. During Usage:
The audio LED indicator of the receiver will
illuminates according to the sound strength
input to the microphone. When the red LED is
illuminated, it denotes the maximum sound
pressure level is being reached but does not
represent distortion.
1. Unscrew battery cap in a counter-clockwise
direction.
2. Insert two 1.5 Volt (AA) batteries into the
battery compartment according to the correct
polarity as shown in Figure 2. The moment the
battery touches the terminals of the
compartment, the indicator will flash briefly .
This means the polarity is correct. However, if
no flash occurs, this indicates wrong insertion
or battery is dead. Please re-insert the battery
according to its correct polarity or exchange it
for fresh batteries. Always change both
batteries at the same time.
BATTERY INSERTION
6
(Figure 2)
OPERATING INSTRUCTIONS
When the microphone is switched on the indicator
will flash briefly indicating normal operation.
NOTE: When microphone is not in use make sure the
microphone is switched off. If the microphone will not
be used for some time, please remove the batteries
from the battery compartment to avoid battery
leakage which could result in damage to the
microphone. If rechargeable batteries are used,
remove and recharge when necessary.
UHF Handheld Transmitter
3 4
UHF Handheld Transmitter
2 6