MIPRO MR-811 Single-Channel Diversity Receiver - Manual (Page 7)

8 9
Single/Dual/Quad Channels Diversity Receivers Single/Dual/Quad Channels Diversity Receivers
Wireless Accessories & Replacement Parts
FB-71: Rackmount kit fits 1 MR-811 or MR-812 receiver alone.
FB-72: Rackmount kit fits 1 MR-811T or MR-812T receiver alone.
FBC-71: Rear-to-front cables only(1-pair). It allows front mount antenna placement
for improved reception quality.
AT-20: Detachable 1/2 Wave Coaxial Antenna.
AD-707a: UHF 4-channel Wideband Antenna Divider System (480MHz ~ 1GHz).
AD-90W: UHF Wideband Directional Antenna (480MHz ~ 1GHz).
AT-70: UHF Ground Plane Antenna (1-pc, 2-pcs recommended)
AT-70B: UHF Antenna Signal Booster (1-pc, 2-pcs recommended)
AD-90S: UHF 4-Channel Wideband Power Splitter.
AT-90A: UHF 4-Channel Wideband Power Amplifier.
AD-808: UHF 4-Channel Active Antenna Combiner.
Installation for dual half-rack receivers into a 1-rack unit for
rackmount purpose
! Unfasten screws for each receiver. Push the receivers next to each other.
! Place holding plates on top and bottom of the two receivers first, and following the
directions, slide both plates into position over the screw holes. Then tighten screws.
Place another holding plate on the rear panel and repeat same procedures. (screws
should be used in their original location; i.e., top screws for top holding plate and
bottom screws for bottom holding plate).
! After both receivers are fixed together, fasten the optional rack mount kit on both
sides of the joined receivers as shown in Figure 7.
! Align and install the optional rack mount kit and fasten with screws on both sides.
(Figure 8)
(Figure 7)
(Figure 8)