MIPRO ACT-50T Bodypack Transmitter - Manual (Page 7)

Setting LOCK
10 11
Bodypack Transmitter Bodypack Transmitter
LOCK
SET LOCK
UNLOCK
SET LOCK
SET
LOCKED
RF POWER
RF-HI
RF POWER
SET
MODE
! Setting LOCK can be switched to LOCK or
UNLOCK mode.
! Press MODE button until SET LOCK mode
appears.
! Press SET button to select the desired
parameter.
! Press MODE button to confirm and save the
change.
! Press SET button twice to remove the LOCK
function.
! The LOCK function will be removed automatically
when losing power.
! Mute function can still work properly when
LOCK.
NOTE: Once locked, all 7 parameter values
cannot be changed.
ERR Message
! When “ERR” appears in the display it indicates
that an operational error has occurred. Please
refer to the following codes to diagnose which
error you are experiencing.
ERR no01 EEPROM is not being programmed or
internal data error.
ERR no02 For testing only.
ERR no03 The frequency you want to program is
above the switching bandwidth of the
transmitter. Use a receiver with an
appropriate frequency group. (At this time
the microphone is still operating and the
frequency remains unchanged. To clear
the displayed "ERR" message, switch the
handheld transmitter off and on again.)
ERR no04 The frequency you want to program is
below the switching bandwidth of the
transmitter. Use a receiver with an
appropriate frequency group. (At this time
the microphone is still operating and the
frequency remains unchanged. To clear the
displayed “ERR” message, switch the
handheld transmitter off and on again.)
! “Group” & “Channel”: When both the group
and channel numbers are displayed, it means
that you are using the pre-programmed
frequency of the receiver.
! “Channel” Only: If “Channel” only is displayed,
it means that you are using a frequency which
is not pre-programmed.