MIPRO ACT-311 Single-Channel Diversity Receiver - Manual (Page 9)

12 13
LCD Screen Displays all Parameter Values
Diversity Wireless Systems Diversity Wireless Systems
Receiver Parameters
4 receiver parameters can be selected and programmed using the SET button. SET
Group
Channel
Frequency
Squelch
Installation for dual half-rack receivers into a 1-rack unit for
rackmount purpose
! Unfasten screws for each receiver. Push the receivers next to each other.
! Place holding plates on top and bottom of the two receivers first, and following the
directions, slide both plates into position over the screw holes. Then tighten screws.
Place another holding plate on the rear panel and repeat same procedures. (screws
should be used in their original location; i.e., top screws for top holding plate and
bottom screws for bottom holding plate).
! After both receivers are fixed together, fasten the optional rack mount kit on both
sides of the joined receivers as shown in Figure 7.
! Align and install the optional rack mount kit and fasten with screws on both sides.
(Figure 8)
(Figure 7)
(Figure 8)