MIPRO ACT-311 Single-Channel Diversity Receiver - Manual (Page 11)

Press
User-Defined FREQUENCY Setting
Blinking FRQ number
Down Up
To exit mode:
FRQ mode deactivates if ▼ or ▲ button is not pressed within 5 seconds and LCD
screen dims if not pressed in 10 seconds.
!
Instructions:
NOTES:
(1) 961 frequencies can be user-defined and up to 8 frequencies can be
stored in Group 11.
1. Press and release the 'SET' button until both icon and group number start to
blink.
2. During blinking, press and release ▼ or ▲ button to group 11.
3. Press the 'SET' button until it stops at FRQ cursor.
4. Press 'SET' button again until the first 3 digit of frequency starts to blink denoting
FRQ it is ready to accept parameter changes.
5. During blinking, press ▼ or ▲ button to decrease or increase parameter value by
1MHz.
6. Press the 'SET' button to confirm the change. Once change is saved, the last 3
digits of the frequency starts to blink.
7. During blinking, press ▼ or ▲ button to decrease or increase parameter value by
25KHz.
8. Press the 'SET' button to confirm the change.
(2) EU/ISM band: Up to 4 frequencies can be stored in Group 2.
9. Up to 8 different frequencies can stored in Group 11- - 01 to 08.
10. Up to 3 different frequencies can stored in Group 2- - 01 to 03 (EU/ISM Band).
Caution:
! The 8 saved frequencies in group 11 and 4 saved frequencies in group 2 (EU/ISM
863-865MHz) may not be compatible and interference-free and therefore, not
recommended to be used simultaneously at the same venue.
User-Defined FREQUENCY Setting
Press
SET
SET
SET
SET
SET
16 17
Diversity Wireless Systems Diversity Wireless Systems