MIPRO ACT-7H Handheld Transmitter - Manual (Page 3)

3 4
PROPRIETARY DESIGN TO AVOID ACCIDENTAL
POWER ON/OFF
REMOVE HANDHELD TRANSMITTER CAP:
Power OFF Transmitter.
Unscrew Lower Housing. Pull out the cap.
INSTALL HANDHELD TRANSMITTER CAP
(Covers On/Off Switch):
Caution: We recommended the cap is fitted during
operation.
(Figure 2)
1. Unscrew lower housing in counter-clockwise
direction.
2. Insert two 1.5 Volt (AA) batteries into the battery
compartment according to the correct polarity as
shown in Figure 2. When batteries are installed
correctly, the battery meter in the LCD screen will
show the current battery strength.
The protective handheld cap prevents accidental
power on/off and protects internal components.
NOTE:
When microphone is not in use make sure the
microphone is switched off. If the microphone will
not be used for some time, please remove the
batteries from the battery compartment to avoid
battery leakage which could result in damage to
the microphone. If rechargeable batteries are
used, remove and recharge when necessary.
Always change both batteries at the same time.
BATTERY INSTALLATION
4
Power ON Transmitter.
Unscrew Lower Housing. Pull out, reverse and
push in cap.
Fasten lower housing back in place
Handheld Transmitter Handheld Transmitter
4